Twin Beech restoration progress.
-
- Posts: 631
- Joined: Wed Jan 15, 2020 9:29 pm
- Contact:
Thanks!
We pulled out the entire remnants of the deice plumbing. I also pulled the interior panels and insulation from the interior today.
I need to get a subwoofer set up in the hangar and just play the 985’s at 1800RPM…
Although that may just put me to sleep.
We pulled out the entire remnants of the deice plumbing. I also pulled the interior panels and insulation from the interior today.
I need to get a subwoofer set up in the hangar and just play the 985’s at 1800RPM…
Although that may just put me to sleep.
You do not have the required permissions to view the files attached to this post.
Twin Beech restoration:
www.barelyaviated.com
www.barelyaviated.com
-
- Posts: 631
- Joined: Wed Jan 15, 2020 9:29 pm
- Contact:
I’m finding a little bit here and there. Which is incredibly impressive since it spent 10 years flying around the Carolina’s and Florida. It’s last home was Key West prior to moving to Wisconsin.
Twin Beech restoration:
www.barelyaviated.com
www.barelyaviated.com
- Colonel
- Posts: 2571
- Joined: Wed Jan 15, 2020 10:02 pm
- Location: Over The Runway
Hope it didn't spend too long in EYW. Everything there rusts.
I've seen chrome-plated metal, hosed down with Corrosion-X that rusted in Key West.
I remember Freddy had to change his (four) aluminum ailerons on his Pitts S-2C.
Never heard of that before. They were corroded out.
I've seen chrome-plated metal, hosed down with Corrosion-X that rusted in Key West.
I remember Freddy had to change his (four) aluminum ailerons on his Pitts S-2C.
Never heard of that before. They were corroded out.
45 / 47 => 95 3/4%
-
- Posts: 631
- Joined: Wed Jan 15, 2020 9:29 pm
- Contact:
Took a deeper dive in the aft floor section and tail.
I learned that draining the oil from the Y coupling leaves about 1.5 gallons for the prop feathering.
So much learning has happened!
Steam spray cleaning the wheel wells earned me a punch through the oil reservoir… Best assumption is that water was in the oil pan, and corroded the base. I learned that draining the oil from the Y coupling leaves about 1.5 gallons for the prop feathering.
So much learning has happened!
You do not have the required permissions to view the files attached to this post.
Twin Beech restoration:
www.barelyaviated.com
www.barelyaviated.com
-
- Posts: 631
- Joined: Wed Jan 15, 2020 9:29 pm
- Contact:
https://barelyaviated.com/progress%3A-p ... /f/washing
I added a few blog posts.
Col:
You asked about corrosion? Well, found a little...
https://barelyaviated.com/progress%3A-p ... -the-weary
PS I was promoted to Colonel as well.
WI wing of the CAF.
It's not as glamorous when everyone else is a colonel too...
Oh well, at least I'm still an actual field grad officer in the military... That and a buck gets me a cup of coffee.
I added a few blog posts.
Col:
You asked about corrosion? Well, found a little...
https://barelyaviated.com/progress%3A-p ... -the-weary
PS I was promoted to Colonel as well.
WI wing of the CAF.
It's not as glamorous when everyone else is a colonel too...
Oh well, at least I'm still an actual field grad officer in the military... That and a buck gets me a cup of coffee.
Twin Beech restoration:
www.barelyaviated.com
www.barelyaviated.com
- Colonel
- Posts: 2571
- Joined: Wed Jan 15, 2020 10:02 pm
- Location: Over The Runway
Congratulations!I was promoted to Colonel as well.
You may recall that Rob Riggle - a pilot, light bird USMCR - said that he took
on the promotional role of Colonel Sanders for KFC, because it was the only
way he was ever going to get to be a Colonel.
"Give me fried chicken, or give me death!"
Pretty stirring words, IMHO.
45 / 47 => 95 3/4%
-
- Posts: 419
- Joined: Sat Feb 22, 2020 5:11 pm
- Location: Onoway, AB
-
- Posts: 631
- Joined: Wed Jan 15, 2020 9:29 pm
- Contact:
Long story, but here it goes…. I have always been a dual citizen (US/Canada). Started driving across Canada on 9/10/01 looking for a job. Ended up lurking in Thompson working at Radio Shack until I could get the privilege to wash airplanes. Finally got that, owner was embezzling money, company shutdown. Off to the next job…spent a year and half in SK sweeping dust on the ramp, enjoying my time freezing my ass off in Stoney Rapids, getting nowhere. Pissed off the owner and was asked to leave, found a job right away in YPA slinging gear on a Navajo, knowing full well it was a potential temporary summer job. Furloughed in September the same year (‘04). Worked a few months in the oil patch pondering life choices, said fuck it. Joined the US Marine Corps. Ate a bunch of crayons and licked windows for several years until getting off of active duty. Spent time in California and Alaska flying/building time, eventually found a freight job flying a Beech 99 in Wisconsin in 2011. Joined the Army National Guard flying the UH60 Blackhawk. Met my wife, started flying for a regional then eventually for a major airline.TwinOtterFan wrote: ↑Mon Oct 04, 2021 3:26 amSounds like Ottawa..... What made you jump over the pond to Wisconsin?
Cost of living is pretty decent, weather is reasonable 10 months of the year for a former Canadian, bought a few toys to have fun with. Too much of logistical nightmare to move when I get all spun up in April when there are occasional snow flurries and I threaten to move to Florida. Plus I’m afraid to fly GA in Florida, too many student pilots.
Twin Beech restoration:
www.barelyaviated.com
www.barelyaviated.com
-
- Similar Topics
- Replies
- Views
- Last post
-
- 2 Replies
- 6373 Views
-
Last post by Slick Goodlin
-
- 0 Replies
- 6668 Views
-
Last post by Scudrunner
-
- 29 Replies
- 5777 Views
-
Last post by Big Pistons Forever