Where are the best FTU's in Canada?
-
- Posts: 13
- Joined: Sat Sep 09, 2017 12:19 am
If the answer is that you can't help construct a better flight school without being staff/owner then perhaps we should start a list of exceptional flight schools in Canada.
Tough one....from my experience I would nominate Brampton Flying Club, Victoria Flying Club, and Harv's Air.
-
- Posts: 1349
- Joined: Thu Feb 13, 2014 5:08 pm
Hard to say but if I had to narrow my search down I would look for ones based at small airports. You won't spend time flying cross country to the "practice area". Nor will you be 6 in the circuit.
I know many places having limits on weather they sent students out in, so look for sunnier places like YYC. Avoid the coast you might not fly for weeks in the winter.
Speak with the instructors and former students.
I know many places having limits on weather they sent students out in, so look for sunnier places like YYC. Avoid the coast you might not fly for weeks in the winter.
Speak with the instructors and former students.
-
- Posts: 13
- Joined: Sat Sep 09, 2017 12:19 am
Hey what's the cost to acquire a s2-b? :)
-
- Posts: 3450
- Joined: Wed Apr 29, 2015 10:31 am
Depends on condition of fabric, prop, engine, avionics (a little bit).
Probably USD$50k to USD$150K would be the range.
Interestingly trade-a-plane.com does not show even [i]one[/i] S-2B
for sale. Most got exported to Europe a few years back when
the dollar was low. There are only a handful in Canada and
don't change hands very often.
I know a really rough, high-time, used-up S-2C that went for
USD$120K (too much) and needed an engine overhaul almost
immediately afterwards. Keep in mind that one new blade for
a claw is $19,000. [i]One blade[/i].
Probably USD$50k to USD$150K would be the range.
Interestingly trade-a-plane.com does not show even [i]one[/i] S-2B
for sale. Most got exported to Europe a few years back when
the dollar was low. There are only a handful in Canada and
don't change hands very often.
I know a really rough, high-time, used-up S-2C that went for
USD$120K (too much) and needed an engine overhaul almost
immediately afterwards. Keep in mind that one new blade for
a claw is $19,000. [i]One blade[/i].
-
- Similar Topics
- Replies
- Views
- Last post
-
- 11 Replies
- 3722 Views
-
Last post by Eric Janson
-
- 24 Replies
- 18125 Views
-
Last post by vanNostrum
-
- 1 Replies
- 765 Views
-
Last post by Scudrunner