Rockwell Commander 690 down at YQT
-
- Posts: 953
- Joined: Thu Jan 16, 2020 3:24 am
Is the NTS system actually selectable on some -331 installations? That’s insane.
-
- Posts: 167
- Joined: Thu Jan 16, 2020 4:21 am
Slick: does the NTS switch have an off position?
That I don't know. I can't find a picture of the overhead panel and the check list only says "Depress and hold".
J
That I don't know. I can't find a picture of the overhead panel and the check list only says "Depress and hold".
J
-
- Posts: 219
- Joined: Thu Jan 16, 2020 4:15 am
The depress and hold is to test the NTS. As far as I know, there is no switch to disable the NTS on a Commander (or Metro).John Swallow wrote: ↑Sun Aug 22, 2021 4:44 pmSlick: does the NTS switch have an off position?
That I don't know. I can't find a picture of the overhead panel and the check list only says "Depress and hold".
J
The NTS system is a mechanical system. I highly doubt one electrical switch could disable it.
- Liquid_Charlie
- Posts: 451
- Joined: Sat Jan 18, 2020 3:36 pm
- Location: Sioux Lookout On.
- Contact:
From all reports there was a loss of control and at that point in the flight there has to be some sort of catastrophic failure. It's been a long time since I flew a 690 but flying 100% engines like the 690 and the herc prop failures is always the most complicated failure to deal with. To me a failure with no NTS or feather and likely a windmilling prop could cause this kind of accident. I doubt he even knew what was happening and at that point just there for the ride. Very tragic and a pilot's worst nightmare. I certainly hope the causes are found out and used to help prevent a repeat.
"black air has no lift - extra fuel has no weight"
-
- Similar Topics
- Replies
- Views
- Last post
-
- 5 Replies
- 6429 Views
-
Last post by Colonel
-
- 2 Replies
- 1550 Views
-
Last post by Nark
-
- 1 Replies
- 8367 Views
-
Last post by Liquid_Charlie