Not sure whats going on with this plane but
This is hard to watch - Pilot Lived
- Scudrunner
- Site Admin
- Posts: 1178
- Joined: Mon Jan 13, 2014 3:18 am
- Location: Drinking Coffee in FBO Lounge
- Contact:
5 out of 2 Pilots are Dyslexic.
-
- Posts: 167
- Joined: Thu Jan 16, 2020 4:21 am
I queried the apparent lack of a propeller right away. Turns out he lost it...
- Scudrunner
- Site Admin
- Posts: 1178
- Joined: Mon Jan 13, 2014 3:18 am
- Location: Drinking Coffee in FBO Lounge
- Contact:
Didn't notice that good eye. I think you need one of those right?
5 out of 2 Pilots are Dyslexic.
- Liquid_Charlie
- Posts: 451
- Joined: Sat Jan 18, 2020 3:36 pm
- Location: Sioux Lookout On.
- Contact:
Looking at the position of the aircraft and it looks like he is pretty hot - my only question is what the fuck was he doing in the first place, we just saw the results. Damn
"black air has no lift - extra fuel has no weight"
-
- Posts: 823
- Joined: Thu Jan 16, 2020 3:16 am
I hope I would have done some S turns on final to try to land at the start of the runway instead of the end, but I suppose one might get distracted.
-
- Posts: 953
- Joined: Thu Jan 16, 2020 3:24 am
From what I’ve heard elsewhere, it was aThatcher CX-4 homebuilt on a test flight that lost its prop. The airport is surrounded by housing so he intended to glide back to the runway. He clearly came in high/hot (I can understand a fear of the opposite though we all saw how this went), then I read he tried a bunch of stuff beyond just braking to try and get it stopped but, again, the whole thing started hot as hell.
Perhaps the big take away after watching this is the idea that not every forced approach will leave you with an airplane that performs the way the one on your flight test did. A windmilling propeller makes a lot more drag than you might expect, for example the Garrett/Hartzell combo at my part time job produces zero thrust at around 20% torque. A little quick math shows that the engine has to produce 143 horsepower just to overcome the drag of the turning propellers, in that particular case. Obviously the Volkswagen(?) engine in that Thatcher wouldn’t have to make so much power just to turn the prop though I imagine the percentage would be about the same.
All that to say that if you’re used to flying your approaches (forced and regular) with idle power, if the prop ever parts company you’ll find your plane will probably float and float and float. Or the opposite if your engine failure kept the prop but opened up your cowl.
Perhaps the big take away after watching this is the idea that not every forced approach will leave you with an airplane that performs the way the one on your flight test did. A windmilling propeller makes a lot more drag than you might expect, for example the Garrett/Hartzell combo at my part time job produces zero thrust at around 20% torque. A little quick math shows that the engine has to produce 143 horsepower just to overcome the drag of the turning propellers, in that particular case. Obviously the Volkswagen(?) engine in that Thatcher wouldn’t have to make so much power just to turn the prop though I imagine the percentage would be about the same.
All that to say that if you’re used to flying your approaches (forced and regular) with idle power, if the prop ever parts company you’ll find your plane will probably float and float and float. Or the opposite if your engine failure kept the prop but opened up your cowl.
-
- Posts: 823
- Joined: Thu Jan 16, 2020 3:16 am
This video has been upgraded to “Impossible” to watch.
-
- Posts: 630
- Joined: Wed Jan 15, 2020 9:29 pm
- Contact:
I don’t remember what I had for breakfast, what’s the run down on the video again?
Twin Beech restoration:
www.barelyaviated.com
www.barelyaviated.com
- Scudrunner
- Site Admin
- Posts: 1178
- Joined: Mon Jan 13, 2014 3:18 am
- Location: Drinking Coffee in FBO Lounge
- Contact:
Shoot I posted it and I can’t remember but Pilots
Lived……..
Lived……..
5 out of 2 Pilots are Dyslexic.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 6 Replies
- 3621 Views
-
Last post by Doin_Time
-
- 8 Replies
- 1630 Views
-
Last post by Slick Goodlin
-
- 56 Replies
- 7267 Views
-
Last post by Scudrunner