I’ve always thought the METAR maps are pretty cool.
Not cool enough to drop $500 on though..
I found a company: wwwdiymetar.com that sells the kit. I wasn’t sure the amount of LED’s I would need, so I ordered the 100 bundle. (They come in a string of 50)
Next hardest part was finding VNC’s (sectionals for you American types).
Went to Office Depot and found a 24”x36” for $20, backing board for $10. Free maps from the airport manager.
It took nearly 3 days to create, because there were 4 sections that needed splicing to extend the wire. I thought I had what I needed. Turns out I didn’t have it on hand and swung by to the hardware store to find 18awg wire. (Where’s radio shack when you need them…) then I ran out of time, in order to pick up jr. from daycare.
Being a cheap-ass pays off.
-
- Posts: 615
- Joined: Wed Jan 15, 2020 9:29 pm
- Contact:
You do not have the required permissions to view the files attached to this post.
Twin Beech restoration:
www.barelyaviated.com
www.barelyaviated.com
-
- Posts: 615
- Joined: Wed Jan 15, 2020 9:29 pm
- Contact:
You do not have the required permissions to view the files attached to this post.
Twin Beech restoration:
www.barelyaviated.com
www.barelyaviated.com
-
- Posts: 419
- Joined: Sat Feb 22, 2020 5:11 pm
- Location: Onoway, AB
I was just looking into making one of these as well, have plenty of old maps and a couple of old pi's sitting around.
What did you use for the brain?
What did you use for the brain?
-
- Posts: 941
- Joined: Thu Jan 16, 2020 3:24 am
That’s awesome, I’ll have to add one to the build list.
-
- Posts: 615
- Joined: Wed Jan 15, 2020 9:29 pm
- Contact:
I used www.diymetar.com
It has a small control box powered by usb. I’m certain there is pi software out there that runs the program.
A lesson learned was not following directions. They called for 3/8 drill to have the LED project through, but I recommend a 1/4 or 5/16 size punch. Drilling will tear the paper map.
Further, if you build your own, you can affix the LED string without the need to splice the kit.
I have a string of 50 LED’s unused, I’ll have to find another use for them. (They get stupid bright)
It has a small control box powered by usb. I’m certain there is pi software out there that runs the program.
A lesson learned was not following directions. They called for 3/8 drill to have the LED project through, but I recommend a 1/4 or 5/16 size punch. Drilling will tear the paper map.
Further, if you build your own, you can affix the LED string without the need to splice the kit.
I have a string of 50 LED’s unused, I’ll have to find another use for them. (They get stupid bright)
Twin Beech restoration:
www.barelyaviated.com
www.barelyaviated.com
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1 Replies
- 4808 Views
-
Last post by Slick Goodlin
-
- 4 Replies
- 1749 Views
-
Last post by Liquid_Charlie
-
- 14 Replies
- 3460 Views
-
Last post by Squaretail